{YTS} How To Fix Windows Installation Errors Using BIOS Recovery

If you’re experiencing Windows installation errors using the BIOS recovery process, here’s a step-by-step guide to help you troubleshoot and fix these issues:

Preparation

Ensure your system is in the correct boot order and has the latest drivers installed.

Make sure your system has a stable power supply and is not running from an external battery.

Step 1: Enter BIOS Setup (F2 or F12 key)

Restart your computer and immediately press the key that corresponds to the BIOS setup (F2, F12, or Del).

If you’re unable to find the correct key, refer to your motherboard manual.

Once in BIOS setup, look for an option labeled “Boot Order” or “Boot Configuration.”

Set the boot order to prioritize your Windows installation over any other operating systems.

Step 2: Check System Logs

Enter the Command Prompt (Command Prompt) by pressing the key you used for entering BIOS setup.

Type dism.exe /online /cleanup-image /restorehealth and press Enter.

This command will scan your system for updates and repair any issues that might be causing the installation error.

Step 3: Run System File Checker (SFC)

Open Command Prompt again by pressing the key you used to enter BIOS setup.

Type sfc /scannow and press Enter.

This command will scan your system for corrupted files and repair any issues that might be causing the installation error.

Step 4: Run DISM (Deployment Image Servicing and Management)

Open Command Prompt again by pressing the key you used to enter BIOS setup.

Type dism.exe /online /cleanup-image /restorehealth and press Enter.

This command will scan your system for updates, repair any issues that might be causing the installation error, and remove corrupted files.

Step 5: Run System Restore

Open Command Prompt again by pressing the key you used to enter BIOS setup.

Type sccmcl.exe (for Windows 10) or vssadmin (for Windows 8/8.1/7) and press Enter.

This command will restore your system to a previous point when it was working properly.

Step 6: Reboot and Try Again

Once you’ve completed all the above steps, reboot your system and try installing Windows again.

Common Issues and Solutions

No boot device: Ensure that your Windows installation is on a physical drive (such as C:) or a network location.

Windows cannot find the file: Check if the file path is correct and ensure that the file exists in the correct location.

Installation failed due to UEFI issues: Try using the Legacy Boot Option in UEFI settings or disable Secure Boot and use the UEFI firmware override.

Additional Tips

Make sure to save your system configuration and restore points regularly to prevent data loss in case of a boot error.

Consider consulting your motherboard manual for specific instructions on entering BIOS setup and troubleshooting BIOS-related issues.

{YTS} How To Fix Windows Installation Errors Using BIOS Recovery

DON'T MISS OUT!